Do Wood Floors Have To Be Refinished After Stripping

Here are four big reasons why.

Do wood floors have to be refinished after stripping.

Your floors are begging you for your help. No vacuums until floors have fully cured. You can paint with pure freedom even using a paint sprayer and spillages rarely cause much damage. Choose the best varnish stripper for your needs.

Apply enough stripper to keep the surface wet and never work in direct sunlight as you can dry the wood. Hit the area with a putty knife to scrape off the stripper along with the finish. If you simply have no floor coverings yet and just a subfloor then you will greatly benefit by painting the walls and ceiling before refinishing the floors. When you have determined that you do need to strip a piece always remove all the old finish or paint thoroughly.

We re getting ready to finish our wood floors some new and some refinish. If you have a piece of wooden furniture you really like or a tired thrift store find with loads of potential give it new life with a fresh coat of stain. Asked this on the flooring forum but not much traffic there these days. When they polyurethane wears off the wood absorbs the water.

Use a stiff paint brush to spread the stripper over a surface of the wood in a thick even layer. Chemical stripping products come in a liquid spray or gel form. Although it gets most of the varnish off the furniture there will be some sanding required after the old finish is removed. That water can come from rain snow pet s paws spilled drink or even just cleaning product through normal maintenance.

Staining floors especially for first time do it yourselfers is a tricky business. See above for full cure times of our most frequently used wood flooring finishes. You can do this in two steps. The equipment used in refinishing floors is noisy.

Do not put too much denatured alcohol in the pan as it does tend to quickly evaporate. Use denatured alcohol in a disposable aluminum pan to clean off the remaining stripper with the help of steel wool. The contractor will sand the old finish off the floors repair any damaged areas and ensure all wood dust is cleared from the floors. Do not use any liquids at all for cleaning any newly refinished hardwood floors until they are fully cured.

Refinishing is an easy low cost way to bring out natural beauty in wood furniture and make fine details shine. And when it does go wrong the only solution is to re sand the floor and start all over from the beginning. Leaving spots will yield an uneven surface when you finally start finishing it. Stain is often applied in two coats and can create a strong odor.

That s why we do our utmost to talk you out of staining your wood floors. When your hardwood turns gray it s definitely time to finish and do it soon before you have more damage. Remove the stripper from the wood. The job begins after the room is fully cleared.