Electrical And Data Separation

It states separations between supply and communication conduit systems.

Electrical and data separation.

Unshielded power lines or electrical equipment in proximity to grounded metal conduit pathway. The main electrical services entrance is protected with surge arresters transient voltage surge suppressor according to the applicable local national codes for equipment safety. I also see this same distance in other specs and publications. All cabling should avoid any proximity to radio or television transmitters beacons and overhead transmission lines.

Minimum separation distance from power source at 480v or less. While code doesn t mandate any separation imo good practice calls for keeping electrical wiring and signal or data wiring at least several inches apart where they run parallel. In class 2 and class 3 systems either the voltage or the current depending upon circuit design is limited to a level that will not cause a fire and under. If open spaced power conductors are used a minimum separation of 50 mm is required.

All data telecommunications or sensitive cabling should not be placed near 3 phase cables as these are normally used for heavy electrical inductive loads e g. It follows that a data communication physical standard such as rs 232e would have a high susceptibility and a 1000 v 200 a ac cable has a low susceptibility. The problem is the possibility of induced noise in the signal or data cable. The electrical wiring will not be affected in any way.

They are considered to be a special condition other than a normal power circuit. Susceptibility in this context is understood to be an indication of how well the signal circuit can differentiate between the undesirable noise and required signal. The text in bicsi s tampa fl tdmm can also be found in the national electrical safety code nesc section 320 b 2 separation from other underground installation. Unshielded power lines or electrical equipment in proximity to open or non metal pathways.

Conduit systems to be occupied by communication conductors shall be separated from conduit systems to be used for supply systems by 75 mm 3 in of concrete 100 mm 4 in of masonry or 300 mm 12 in of well tamped earth. There are four classification levels of susceptibility for cables. Power control wiring separation if you are asking separation needed for interference not code we usually use 12 separation between lv signal cabling and line voltage cabling as a general rule.